10
Exit:
Exit configuration setup. Press
MENU
button to select the
Exit
option and
press
UP
button to exit the menu.
3.1.4.
Mode menu
In System menu, press
M
button
to select
Mode: XXX
and press + or – button to enter the
password: +-MC+-, will pop up the below interface:
Figure.3.1.4.1 Mode menu
Gain: XXX
Gain value, range: 0~+255;
Bright: XXX
Brightness value, range: -2048~+2048;
Save: XXX
Save configuration setup;
Exit:
Exit configuration setup. Press
MENU
button until
Exit
option is selected and
press
UP
button or
DOWN
button to exit.
3.2.
Main operation description
3.2.1.
Focusing
When there is no menu displayed, press
UP
or
DOWN
button to adjust the focus, or press the
UP
and
DOWN
buttons at the same time to do autofocus.
3.2.2.
Single pixel correction setup
Press
C
button
to do single pixel correction.
Note:
Camera will do single pixel correction automatically for several time when power on.
After start-up, since the camera is in thermal equilibrium processing, it may need single pixel
correction for several times. After about 45 minutes, the system reaches thermal equilibrium.
Mode: Gain: Bright: Save: Exit: