8
3. The required cable specification, quantity, direction and laying
position need to match construction requirements, and cable
length depends on actual position;
4. All the cable cannot have break-down and terminal in the
middle;
5. Cables should be straight in the hallways and turning;
6. Cable should be straight in the groove, and cannot beyond the
groove in case of holding back the inlet and outlet holes. Cables
should be banded and fixed when they are out of the groove;
7. User cable should be separated from the power lines. Cables,
power lines and grounding lines cannot be overlapped and mixed
when they are in the same groove road. When cable is too long,
it cannot hold down other cable, but structure in the midd le of
alignment rack;
8. Pigtail cannot be tied and swerved as less as possible.
Swerving radius cannot be too small (small swerving causes
terrible loss of link). Its banding should be moderate, not too
tight, and should be separated from other cables;
9. It should have corresponding simple signal at both sides of the
cable for maintaining.
【
Specifications
】
Technology
Standard
：
IEEE802.3
、
IEEE802.3u
、
IEEE802.3x
、
IEEE802.3z
Transmit Rate
：
148810pps
Max Rate of Filtrate
：
148810pps
Processing type: Store and Forward
MAC address
：
8K
Interfaces
RJ45 port
：
10/100BaseT(X) auto connection, Full /Half duplex
or force work mode, and support MDI/MDI-X connection
Summary of Contents for IT-ES2010-IU-2GS-4F Series
Page 10: ...10 Certifications...
