PRODUCT SPECIFICATIONS
Range:
11 m x 11 m
Alarm relay:
Energized Form A
125 mA, 25 VDC, 20 Ohm series resistor
Tamper:
NC, 50 mA, 24 VDC
Power requirements:
7.5 - 16 VDC
25 mA typical, 30 mA maximum, 12 VDC
AC Ripple: 3 V peak-to-peak at nominal 12 VDC
Microwave frequencies:
24.125 GHz
PIR white light immunity:
6,500 Lux typical
Fluorescent light filter:
50 Hz
RFI immunity:
30 V/m,10 MHz - 1000 MHz
Operating temperature:
-10
o
to +55
o
C (14
o
to +131
o
F)
5 - 95% relative humidity (non-condensing)
Self-test intervals:
Microwave Supervision
Every 5 seconds
PIR self-test
Once every hour
Temp. Comp.
Every 30 seconds
PIR fields-of-view:
Standard Wide Angle Lens
22 long range edges
12 intermediate edges
6 lower edges
* 4 look-down edges
Dimensions:
11.9 cm H x 7.1 cm W x 4.2 cm D
Sensitivity:
Standard 3 - 4 steps
Harsh 4 - 5 steps
© 2001 IntelliSense
®
IntelliSense and DUAL TEC are registered trademarks of Honeywell, Inc.
All other trademarks are the properties of their respective owners. All rights reserved.
5-051-661-00 Rev A
LED INDICATORS
DIP SWITCH SETTINGS (SW1)
Factory default settings are shown in grey.
DETECTION PATTERNS
DT-7435
EU
DUAL
TEC
®
M
otion
Sensor
Product
Information
TROUBLE SHOOTING
Problem:
Red LED is flashing rapidly.
Explanation:
The sensor is in one of three conditions:
Microwave supervision failure: The sensor continues operating using PIR
as the only detection method. When detection occurs on the PIR channel,
the alarm relay will latch open until the Microwave trouble is removed.
PIR self-test failure: Alarm relay does not actuate.
Temperature compensation failure: When alarm occurs, the alarm relay
will latch open until the trouble is cleared.
Solution:
Power down the sensor or enter zone finder mode which will
perform self-test. If the trouble does not clear, replace the sensor.
Power Up
Slow
Blink
OFF
OFF
DT-7435 EU Top View
Wide Angle Lens
11 m
SPECIAL INSTRUCTIONS FOR INSTALLATIONS CONTAINING PETS
To take full advantage of the pet immunity the following guidelines should be
followed:
Mount the center of the detector 2.3 m high.
Ensure that the look-down mask is in place (see Step 2).
Mount where animals cannot come within 1.8 m of the detector by
climbing on furniture, boxes or other objects.
Do not aim the detector at stairways that can be climbed by animals.
Notes:
This sensor will provide immunity to false alarms for an individual animal or a
group of animals whose total weight is equal to or less than 45 kilograms.
DT-7435EU
Side View
Wide Angle Lens
*
Look-down fingers are enabled
only when the look-down mask is
removed (see Step 2).
LED
Red
Yellow
Green
Normal
ON
Alarm
ON
Microwave
ON
PIR
Trouble
Fast
Blink
OFF
OFF
Zone Finder
OFF
ON
Microwave
ON
PIR
OPERATION
S
witch
1
2
OFF
Harsh Sensitivity
LED Disabled
ON
Standard Sensitivity
LED Enabled
