WARNING! Never accidentally short together the positive (+) and negative
(-) input connections when connected to 12V DC power. Failure to do so
could result in permanent damage to the power source and the charger.
It’s recommended to disconnect the charger from input power when not
in use.
IntelliPeak Ice has 6 programming screens. Refer to the Main Programming
Menu flowchart included with this manual for an overall view of Ice’s
programming. The most commonly used screen is the “Main Memory” screen
shown at the far left on the flowchart. To move to any menu to the right of the
Main Memory screen (such as the Motor Break-in or Cycle Data menu, etc.)
press
➔
. Press to move left, back towards the Main Memory screen.
As shown in the Main Memory screen at
right, and within any screen, rotate the
dial to move the cursor arrow up or down
the screen. The LCD screen shows 8
lines, but there may be more than 8 lines
of features to be viewed depending on
the menu. If so, continue to move the
cursor downwards and the extra lines will
automatically scroll up for viewing.
As shown below, press the dial to
highlight the first adjustable feature on
any line. If there is more than one adjustable feature on any line, press or
➔
as necessary to highlight the proper value. Rotate the dial to adjust the
highlighted value. Re-press the dial to confirm the selection.
The purpose of all the menus is as follows:
1. MAIN MEMORY: To store battery information, set battery type, set charge
and discharge currents and voltages, set discharge and cycle parameters,
set maximum battery temperature, and to start charge, discharge or
cycle functions.
NAVIGATING THE MENUS
8
➔
➔
