15
4.1 Prepare your PC to configure the WLAN Broadband Router
For Windows 2000/ XP:
1. Click the
Start
button and select Settings, then click
Control Panel
. The
Control Panel
window will
appear.
2. Double-click the right mouse button on the
Network and Dial-up Connections
icon. Double-click the
Local Area Connection
icon. The
Local Area Connection
window will appear. Click the
Properties
button in the
Local Area Connection
window.
3. Check the installed list of
Network Components
. If TCP/IP is not installed, click the
Add
button to
install it; otherwise, go to Step 6.
4. Select
Protocol
in the
Network Component Type
dialog box and click the
Add
button.
5. Select
TCP/IP
in the
Microsoft of Select Network Protocol
dialog box, then click the
OK
button to
install the TCP/IP protocol. It may need the Microsoft Windows CD to complete the installation. Close
and go back to the
Network
dialog box after the TCP/IP installation.
6. Select
TCP/IP
and click the properties button in the
Network
dialog box.
7. Select Specify an IP address and type in values as per the following example.
IP Address:
192.168.1.1
— any IP address within
192.168.1.1
to
192.168.1.254
is good to
connect the Wireless LAN Access Point.
Don’t use 192.138.2.1.
IP Subnet Mask:
255.255.255.0.
8. Click
OK
to complete the IP parameters setting.
For Windows Vista / 7:
1. Click the
Start
button and select
Settings
, then click
Control Panel
. The
Control Panel
window will
appear.
2. Double-click the right mouse button on
Network Connections
. The
Network Connections
window
will appear. Double-click the
Local Area Connection
icon, and the User Account Control window is
shown. Right-click on the Continue button to set properties.
3. In the
Local Area Connection Properties
window, choose the
Networking
tab and click
Internet
Protocol Version 4 (TCP/IPv4)
, then click on the
Properties
button.
4. Click on the
General
tab, select
Specify an IP address
and enter values per the following example.
IP Address:
192.168.1.1
—
any IP address within
192.168.1.1
to
192.168.1.254
is good to
connect the Wireless LAN Access Point.
Don’t use 192.168.2.1.
IP Subnet Mask:
255.255.255.0
5. Click
OK
to complete the IP parameters setting.
6. NOTE: Procedures for Windows 8 are similar.
Summary of Contents for 525497
