/
Steppy 3U Manual
All buttons will flash quickly to indicate that the preset has been loaded and is
now active (further indicated by the fact that the button corresponding to the
loaded preset is now flashing rapidly).
To delay loading of a preset until the start of the next cycle
:
1. Press the red
EDIT
button to enter Edit mode.
2. Press the
LOAD
button.
The
LOAD
button glows
red
and some of the buttons light in the left column to
display the status of the eight presets, as outlined previously.
3. Long-press ( > 1 sec) one of the 8 buttons in the left column.
All buttons will flash quickly to indicate that the preset request has been received.
However, the new preset will not load until the current pattern completes the
cycle on Track 1.
To delete a preset from memory:
1. Press the red
EDIT
button to enter Edit mode.
2. Short-press (< 1 sec) the
LOAD
button followed by the left-column button
corresponding to the preset you want to delete.
This loads that preset into active memory (as indicated by the rapidly flashing
button).
3. Long-press (> 1 sec) the
LOAD
button. All buttons will flash, and the contents of
the previously selected preset will be deleted.
NOTE 1 : To erase ALL presets from memory, turn off Steppy, then long-press the LOAD
button while you power it back on.
NOTE 2 : If you power Steppy off and back on, it will reload that last saved or loaded
preset — it does not retain any unsaved pattern or track changes. So remember to
always save your work if you wish to return to it later.
10. Value buttons
Use this left column of buttons to set values for the parameters you select with the right
column of buttons. In general, this column behaves like an inverted vertical value slider,
with lower values at the top and higher values at the bottom. The specific values
assigned to each button depend on the parameter being edited, and these exact values
are detailed under each parameter button’s description, above.
Page 27