Connecting the Pedal I/O to a 7U Case
The
Pedal I/O 1U
module ships with a 3-wire link cable. Use this to connect the
Pedal I/O
to either a
Pedal I/O Jacks
module or to a compatible case with built in ¼” jacks.
If you’re connecting to a 7U case, first determine whether it has a 1st or 2nd generation Audio Jacks
board. 1st gen boards (included with cases built before early 2019) have a single connector (other
than the power connector). 2nd gen boards have a large shrouded header flanked by two smaller
shrouded headers, flanked by two link connectors at either end.
Connecting to a 2nd Generation Audio Jacks Board
If your case has a 2nd generation board, you can
connect the link cable directly between the
Pedal I/O 1U
module and one of the two link
connectors on your
Audio Jacks Board
.
The connectors are keyed, so you can orient them
only one way.
The left connector sends/returns from the left pair of
jacks and the right connector sends/returns from the
right pair of jacks. You can connect two Pedal I/O’s to a
single Audio Jack board if you wish.
Pedal IO 1U System Manual
