µJack Manual
Installing Your Module
When installing or removing a module from your case always turn off the power to the case and
disconnect the power cable. Failure to do so may result in serious injury or equipment damage.
Ensure the 10-pin connector on the power
cable is connected correctly to the module
before proceeding. The red stripe on the
cable must line up with the -12V pins on the
module’s power connector. The pins are
indicated with the label -12V, a white stripe
next to the connector, the words “red stripe”,
or some combination of those indicators.
Most modules will come with the cable already connected but it’s a good idea to double check
the orientation before proceeding. Be aware that some modules may have headers that serve
other purposes so ensure the cable is connected to the right one.
The other end of the cable, with a 16-pin
connector, connects to the power bus board
of your Eurorack case. Ensure the red stripe
on the cable lines up with the -12V pins on
the bus board. On Intellijel power supplies
the pins are labelled with the words “-12V”
and a thick white stripe.
If you are using another manufacturer’s
power supply, check their documentation for
instructions.
Page 4
