Intelbras IVP 9000 MW MASK, User Manual

Page: 17 / 21

17
5. Operation
When turning on the sensor, the blue LED flashes for approximately 60 seconds. This time is necessary for the stabilization
of the circuits that make up the sensor. After this period, if they are enabled, the LEDs light up with each motion detection.
The LEDs have automatic intensity adjustment according to the brightness of the installed environment.
» Blue LED: alarm
» Yellow LED: Pir
»
red LED:
microwave
5.1. Remote self test
With this function it is possible to remotely enable or disable the visual indication of the LEDs and thus
remotely perform a test run of the product.
For this, it is necessary to combine the adjustment of the LED switch with the voltage applied to the LED input
of the product.
For more details on the functioning adjustment, see item
4.2. Operating mode settings
5.2. Self sabotage
For each of the attempts to tamper with the sensor, the red LED flashes quickly and the PROBLEM output acts to indicate
the type of tampering.
It is highly recommended that the TROUBLE output be connected to a zone of the control panel with 24-hour function
enabled.
Sensor output indication table
Exit
Cause Solution
Alarm Problem
Open and restore Closed
Trigger (PIR and Microwave)
or anti-camouflage
Check the conditions of the installed environment and make the best
microwave setting.
Open Open Masking Check sensor lens for obstruction.
Closed Open Low supply voltage level Check if the sensor supply voltage is greater than 9 V.
Closed Open and restore Position change
Check if the sensor has changed its installation position or if it is not
properly fixed.