Intel® RAID Controller SRCSASJV Hardware User’s Guide
10
3
Intel
®
RAID Controller SRCSASJV
Characteristics
Figure 4. Card Layout
Jumper
Description
Type
Comments
J1
Serial UART
4-pin
Debug header. Factory use only
J2
I2C header
3-pin
Enclosure management support, usually for non-
expander hot-swap backplane
J8
Mode selector
2-pin
Default is for no jumper
J9
Cache write
pending LED
2-pin
Provides signal to enclosure to indicate that the
cache needs to write data
J10
RAID Smart Battery
connector
20-pin
Cable connector to the battery backup pack. This
connector is on the back of the card
