Intel
®
Server System R2000WT Product Family System Integration and Service Guide
11
1.3.2
8 x 3.5” Front Drive Bay Module Installation (Intel® Server Chassis
R2000WTxxxx Only)
This section describes the installation of Intel Accessory Kit A2U8X35S3HSDK into an Intel® Server Chassis
R2000WTxxxx. Skip this section if your chassis already has a drive bay installed.
Remove Drive Bay Retention Bracket and I/O Bay Module Retention
Screws
•
To extract the drive bay retention bracket, remove the 6 fastener screws from the top front edge of the
drive bay (See Letter ‘A’) and pull out the metal bracket (see letter ‘B’)
•
Remove the 2 fastener screws from the back edge of the drive bay over the I/O Bay Module (see letter ‘C’)
Remove Drive Bay Filler Panels and I/O Bay Module
•
Carefully place the chassis on its side
•
From the bottom of the chassis, remove the fastener screws securing the drive bay filler panels and I/O
Bay Module (see letter ‘C’)
•
Carefully return the chassis to its original position
•
Slide out the drive bay filler panels (see letter ‘D’)
•
Carefully slide out the I/O Bay Module. Cables do not need to be disconnected from the I/O Bay Module
