Intel® Server Board M10JNP2SB User Guide
36
9.
Server Board and Essential System Component Installation
and Removal
This chapter provides instructions for installation and removal of the following components:
•
Server board
•
Processor
•
Memory (DIMMs)
•
SATA drives
•
System fans
Before You Begin
Before working with your server board, observe the safety and ESD precautions found in the Product Safety
Overview section at the beginning of this manual.
Perform the following steps prior to install the server board into a chassis.
1.
Make sure the selected chassis supports the Micro ATX board form factor.
2.
Make sure the selected chassis has the necessary standoffs installed. These standoffs are usually metal
and are gold in color. Intel recommends using metal standoffs with screws that will fasten the server
board more securely in place. To confirm standoff placement, lay the server board inside the chassis and
align the mounting holes of the server board to the standoffs inside the chassis. Figure 18 shows the
location of the server board mounting holes. Some chassis include plastic standoffs instead of metal
ones.
Figure 18. Server board mounting hole location
Summary of Contents for M10JNP2SB
Page 2: ... Blank page ...
Page 15: ...Intel Server Board M10JNP2SB User Guide 15 Figure 4 Component height restrictions ...
Page 16: ...Intel Server Board M10JNP2SB User Guide 16 Figure 5 Major components and connectors 1 of 2 ...
Page 17: ...Intel Server Board M10JNP2SB User Guide 17 Figure 6 Major components and connectors 2 of 2 ...
