Intek M-150 Plus, Owner'S Manual

Page: 4 / 32

Controls, Indicators and operation
- 2 -
Front panel
1. AM/FM and UK/CEPT Key
AM/FM SELECTOR
Shortly press the AM/FM Key (1) to select the AM or FM operating mode in both RX and TX. The AM/FM operating
mode selection is possible only if it is allowed the programmed frequency band, otherwise the selection is not possible.
UK/CE SELECTOR
If the UK (United Kingdom) frequency band has been programmed, press this key for about 2 seconds to select the
UK channels/frequencies or the CE channels/frequencies. The channel display will show "U" for the UK
channels/frequencies and "C" for the CE channels/frequencies.
2. AM/FM Indicator
This green-red dual color LED indicator lights up in green color when radio has been set to the AM (Amplitude Modulation)
operating mode and in red color when radio has been set to the FM (Frequency Modulation) operating mode.
3. EMG (Emergency Channels) Key
This key allows quick access to one of the two pre-programmed emergency channels (CH9 or CH19). Each time this key is
pressed, radio will select CH9, then CH19, then again the normal operating channel. When one of the emergency channels
is selected, the LED indicator (4) is lighted. The operating mode (AM or FM) for the emergency channels is factory pre-
programmed as per the following table.
English
FREQUENCY BAND
ID CODE
CH-9
CH-19
E1
AM
AM
I2
AM
AM
DE
AM
AM
D2
AM
AM
EU
AM
AM
CE
FM
FM
UK
FM
FM
PL
AM
AM
1
OFF/VOLUME AS/SQUELCH CHANNEL
TX
RX
AM/FM EMG ANL RB
M-150 PLUS
MULTISTANDARD CB RADIO
DN
UP
UK/CEPT PA
2 3 4 5 6 7 8 10
17 16 15 14 13 12 11
9