89
LTE with the Sony DXC-930 or DXC-950
The camera will control the integration timing.
Jumper Setting
JP 1 & 2 Off
JP 5On
Cable
Custom cable will be needed. Pin 25 on the DB-25 should be connected
to pin 7 on the RGB DB-9. You must also sync on Green.
Software
Need version 3.0 or later of Integrals FPG.
Setup Instructions
1. Start FPG.
2. Open Tools.
3. Select Advanced Configuration.
4. Select the Camera Type.
Select 2.
5. Set LTE Max MS.
Move the slider bar to select the maximum number of milliseconds
you wish to integrate.
The camera controls the timing of the integration. Therefore, the
number of milliseconds selected here will be a maximum number
that is greater than the actual number which is selected on the
camera.
If you wish to change this number, you must select the number of
milliseconds desired and then turn LTE Enable Off, then On again.
6. Keep Syncmode off.
Unless the grabs look out of sync, then turn this on. This is generally
preferable when the image is changing drastically from dark to bright
as can be the case with an LTE source.
7. Turn LTE Enable on.
This will automatically turn the LiveMode on.
8. Select OK to close the Advanced Configuration menu.
9. Open File.
10. Select Save Settings.
The LTE settings from FPG
will now be used by the
TWAIN and ImagePro
drivers.
Summary of Contents for FlashPoint 128 CPCI
Page 2: ...2...
Page 58: ...Special Drivers Chapter 6...
Page 77: ...Appendix A...
Page 88: ...Appendix B...
