Integra RDV-1, Instruction Manual, Page: 58 / 64

58
RDV-1 US/Asia 29342995
1
2
3
DVD MODE
SEND/LEARN
indicator
5 to 15 cm
RECEIVER MODE
: Buttons that can be programmed.
This remote controller features a learning function that allows you to program the remote codes of other remote
control units for more singular control of your home entertainment system. A number of commands can be
programmed for operation for when the remote controller is in DVD mode and when it is in Receiver mode. Please
follow the procedure in this section to program your remote controller to your preferences.
Programming procedure
The first step in the procedure is to determine whether the new command is to be learned in the DVD mode or in the
Receiver mode. Generally speaking, this should be decided by the command being learned. After deciding which
mode is to be used, you will then transfer the individual commands from the other remote control unit to the RC-439DV
remote controller one at a time. Each command is then programmed to one of the available buttons on the RC-
439DV remote controller.
Even after the commands have been programmed, keep the other remote control unit in a safe place in the case
that the programmed commands should be lost (e.g., when the batteries run down). If the commands are lost, it will
then be necessary to program them again.
While pressing and holding down
the desired MODE button (DVD or
RECVR) on the remote controller,
press SEARCH and then release
both buttons.
When you press and hold down the desired
MODE button, the SEND/LEARN indicator
lights up. When you press
SEARCH , the
indicator turns off. When you release both
buttons, the indicator lights up again.
Press and release the button on
the remote controller to which you
want to transfer the new
command.
The buttons that can be selected in this step
depend on the mode. Refer to the shaded
areas in the illustrations below to determine
what buttons can be programmed in each
mode.
If you press the wrong button by mistake,
press that same button again. The SEND/
LEARN indicator flashes three times and the
remote controller exits the programming
mode. When this is the case, start again at
step 1.
Place the remote controller and
the other remote control unit of the
other component facing each
other at a distance of 5 to 15 cm
apart.
RC-439DV
RDV-1(US_E)p56-60.p65 10/4/00, 17:06 58