76
Zone 2
—Continued
Adjusting the Volume for Zone 2
To Mute Zone 2:
Press the remote controller’s [Zone 2] button, followed
by the [Muting] button. To unmute Zone 2, press the
remote controller’s [Zone 2] button again, followed by
the [Muting] button, or adjust the volume for Zone 2.
Notes:
• Only analog input sources are output by the ZONE 2
OUT jacks and ZONE 2 SPEAKERS terminals. Digi-
tal input sources are not output. If no sound is heard
when an input source is selected, check to see if it’s
connected to an analog input.
• When the ZONE 2 SPEAKERS terminals are used,
listening modes that require surround back speakers,
such as Dolby Digital EX and DTS-ES are unavail-
able.
• While Zone 2 is on, the
functions do not work.
• You can’t select different radio stations for the main
room and Zone 2. The same radio station will be used
for both.
Adjusting the Tone and Balance for Zone 2
You can adjust the bass, treble, and balance for Zone 2.
■
Bass
You can boost or cut low-frequency sounds output by the
front speakers from –10 dB to +10 dB in 2 dB steps.
■
Treble
You can boost or cut high-frequency sounds output by
the front speakers from –10 dB to +10 dB in 2 dB steps.
■
Balance
You can adjust the balance of the left and right speakers
in Zone 2 in 2 dB steps, +10 dB to the right and +10 dB
to the left.
The balance cannot be adjusted when the Powered
Zone 2 setting is set to Not Act (page 74) or the Zone 2
Out setting is set to Fixed (page 74).
1
On the remote controller, press
the [Zone 2] Remote Mode but-
ton, and then use the [Level–]
and [Level+] buttons.
On the AV receiver, use the
Zone 2 Level [
]/[
] buttons.
The volume can be set to –
∞
dB,
–81 dB –80 dB through 0 dB in Rela-
tive display (Min.1 through 81, Max in
Absolute display).
If your Zone 2 speakers are connected
to a receiver or integrated amp in Zone
2, use its volume control to adjust the
volume.
Zone 2 Level ,
AV receiver
1
Press the [Zone 2] button, and
then press the [Tone] button
repeatedly to select Bass, Treble,
or Balance.
2
Use the Tone [+] and [–] buttons
to adjust.
2
1
DTR-5.6.book Page 76 Thursday, September 22, 2005 5:07 PM
