AirSense
Model I-310en Operator’s Manual
10/16/11
Page:
1
Preface
This manual describes the Model I-310en of the AirSense I-310
Carbon Dioxide sensor family. The I-310en, while similar in
external appearance and operation to previous 310e models,
has a slightly modified feature set and differences in the
location and operation of the user interface.
Model Identification
Because of its similarity to previous models, the Model
I-310en is most easily identified by the prefix “
M310en
” on
the unit’s serial number tag visible on the sensor circuit
board when the cover is removed.
All other AirSense I-310e series sensors are covered in the
AirSense Model
I-
310e Operator’s Manual
.
Introduction
The AirSense Model I-310en is a non-dispersive infrared
analyzer for measuring environmental CO2 concentration in
ventilation systems and indoor living spaces. Its default
measurement range of 0 - 2000 ppm (parts per million; 1000
ppm = 0.1%) covers the range required to monitor
compliance with ASHRAE or other ventilation efficiency
standards. For specialty applications the measurement range
can be easily increased up to 5000 ppm.
Packaged in a compact, distinctively styled enclosure, the
Model I-310en can be discreetly installed anywhere from the
board room to the boiler room. Standard center wiring
access, fully floating outputs and power/signal mis-wiring
protection make installation a snap.
The Model I-310en provides several output alternatives. A
voltage or 4 - 20 mA current output is standard. An optional
LCD readout is available
.
An optional relay contact can be
configured to open or close above a user-adjustable setpoint.
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Specifications subject to change without notice. | 111011 | PRE 200217 | Page 4 of 17
I-310eN – UserManual
