AirGate-Modbus
INTAB INTERFACE-TEKNK AB
9/22
Fig. 9 -
Communication of
DigiConfig
•
Serial Port = USB Serial Port (COM X)
•
Baud rate = 115200
•
Parity = None
•
Stop Bits = 2 bits
•
Timeout (msec) = 1000
CONFIGURATION MODES
AirGate-Modbus
is configurable through
DigiConfig
software via USB interface, being necessary to put the device in “setup mode”.
To enter this mode, simply press the SETUP BUTTON, checking that the STATUS LED now flashes slowly (approximately once per
second). In “setup
mode
” the device stops behaving as a gateway from a Modbus network and starts to accept the configurations.
In the main screen of the
DigiConfig
software (
Fig. 12
) the following configuration must be seen:
•
Initial Address = 246
