© Intatec Ltd. 2016
27-05-16
Intatec Limited, Airfield Industrial Estate, Hixon, Staffordshire, ST18 0PF
Tel:
01889 272 180
Fax:
01889 272 181
email:
web:
www.intatec.co.uk
E. & O.E
NC230CP Non Concussive Basin Tap
Installation and Operating Instructions
Operating
To turn on the mixer push down on the control knob until it contacts a
stop and then release, mixed temperature water will flow for
approximately 15 seconds.
If more water is required push again.
Rotating the control knob anticlockwise progressively closes the hot
water port and opens the cold water port until it is fully open when only
cold water flows when the mixer is turned on.
Rotating the control knob clockwise progressively closes the cold water
port and opens the hot water port until it is fully open and water at the
maximum temperature flows when the mixer is turned on.
Aftercare
The aerator should be cleaned periodically to remove any build up of
debris or deposits which may affect the performance of the mixer.
Inta mixer taps have a high quality finish and should be treated with
care.
An occasional wipe with a mild washing-up liquid on a soft damp cloth
followed by a thorough rinsing is all that is required.
Do not use an abrasive or chemical household cleaner as this may
cause damage.
Servicing Instructions
If the control knob cannot be depressed fully or does not return to its
initial position within 15 seconds, or the temperature cannot be adjusted
easily or water does not flow in a steady stream the mixer may require
servicing.
Turn off the hot and cold supplies to the mixer.
Remove the cover, unscrew the retaining screw and carefully remove the
control knob ensuring the return spring does not escape and cause
injury.
Using a suitably sized spanner remove the cartridge from the body.
Remove any debris that may have collected within the body, ensure the
stem rotates freely and can be depressed.
Do not attempt to dismantle any part of the cartridge, if necessary
replace with a new cartridge.
Check the ‘O’ rings and return spring for any sign of damage and
replace if necessary.
Using washing up liquid as a lubricant, to ease assembly and prevent
damage to the ‘O’ rings, re-assemble the cartridge into the body and
tighten.
Re-assemble the other components in the reverse order and turn on the
water supplies.
Check the mixer for correct operation.
Push down fully to turn
on mixed water
Turn clockwise to
increase Hot Water
Turn
anticlockwise
to increase
Cold Water
Cover
Retaining screw
Control knob
Return spring
Cartridge
Body
Nozzle
Retaining ring
Gasket
Control knob
bush
