© Intatec Ltd 2015
5
Activating
1 Check that the sensor windows is cleaned and remove any potential objects.
2 Open the isolation valves on the water supplies.
3 Fit the batteries inside the box/power supply unit, connect cable from the power supply unit
(3) to the cable (8) from the tap.
4 The LED in the sensor window flashes: when it stops flashing the taps is ready for use.
Setting the Detecting Distance
The detecting distance of the sensor is set at 12 cm but can be reset by the user from a
minimum of 5cm to a maximum of 25 cm (approximately).
1 Remove the battery from the box or turn off the power at the socket.
2 Wait 30 seconds and reconnect the power supply.
3 When the red LED flashes (if it switches off, it is necessary to remove the battery from the
box and repeat the operation), put one hand immediately in front of the sensor (at a
distance of max. 5cm.
4 When the red LED lights up permanently, move your hand to the desired distance.
5 Wait for the LED to switching off before removing your hand, at this point the new distance
is recorded. This new setting will be stored in case of battery replacement (or lacking of
electricity).
Safety Device
To prevent flooding of the premises following an act of vandalism or misuse (an object left in
front of the sensor or a dirty sensor), the tap has a safety device that shuts off the water flow
after about one minute.
Once the object has been removed (or the sensor has been cleaned), the tap starts working
again. Taps with a power supply unit have an anti black-out function which ensures the water
flow stop if the electricity supply fails and prevent it starting again until the electricity supply
has been restored.
Maintenance
Cleaning
In order to keep the tap operating efficiently and maintain its appearance it is necessary to
periodically carry out a number of simple maintenance operations including:
The high quality chrome finish and the darkened plastic window which protects the sensor,
must be kept clean to maintain correct operation, both surfaces should be treated with care.
An occasional wipe with a mild washing-up liquid on a soft damp cloth followed by a
thorough rinse and wipe dry with a soft clean cloth is all that is required.
Do not use an abrasive or chemical household cleaner as this may cause
damage to the surface.
