© Intatec Ltd 2015
1
Introduction
These instructions cover the installation, operation and maintenance of the IR180CP infra red
tap. Please read the enclosed instructions before commencing the installation of this product,
please note;
We recommend that the installation of any Inta product is carried out
by an approved installer.
The installation must be carried out strictly in accordance with the Water Supply (Water Fitting)
Regulations 1999 and any local authority regulations.
If in doubt we recommend that you contact WRAS - Water Regulations Advisory Scheme on
Tel: 0333 207 9030, your local water authority - details available on the WRAS website or
the Chartered Institute of Plumbing and Heating Engineers on Tel: 01708 472 791.
Products
Infra Red Basin Tap
IR180CP.1
Check Content
Before commencing remove all components from packaging and check each component with
the contents list.
Ensure all parts are present, before discarding any packaging. If any parts are missing, do not
attempt to install your Inta shower valve until the missing parts have been obtained.
Technical Data
Operating water pressure range: 1 to 8 bar (recommended max 5 bar)
With water pressure in excess of 8 bar
use with a pressure reducing valve
Water temperature operating range: 5 to 65 °C
Power supply: 6V lithium battery mod. CRP-2 or
230V AC main powered / 6V DC
w/safety device anti black-out.
Operating
Putting your hands under the aerator and infront of the sensor starts the water flow.
The tap shuts off when hands are removed or after one minute of water flow.
The mixed water temperature can be increased or reduced by adjusting the lever on the side of
the tap.
