DIRECTIONS
1.
Towel dry hair to remove excess moisture. Blot with the towel rather than
rub the hair to avoid causing excess frizz and split ends.
2.
Comb through and detangle the hair with a wide toothed comb.
3.
Plug TURBO MAX Ionic Dryer into an electrical outlet and turn it on by
rolling the heat selection switch up from the OFF position.
4.
Select high or low heat and rotate Infinity Dial up to increase airflow to
desired power. Select your desired Ion output level low or high. (select
high to dry thicker, coarser hair and for greater frizz control)
5.
Direct the TURBO MAX Ionic Dryer at the hair and not the scalp. Begin by
briskly blowing it all over the hair to remove excess water.
6.
When hair is mostly dry, section the hair and begin to style. Begin at the
nape of the neck and brush hair while following the motion with the TURBO
Ionic Dryer. Work up to the scalp, sides and front of the hair.
7.
Once desired style is complete, press the Cool Shot button to set the style
and lock in your look.
SAVE THESE INSTRUCTIONS
INFINITY DIAL
Precision control for
customized airflow
ION SWITCH
9’ PROFESSIONAL
POWER CORD
2 HEAT SETTINGS
CHROME RING
GROUND FAULT CIRCUIT INTERRUPTERS (GFCI)
If you must use appliance in the bathroom, install a GFCI now. A GFCI is a
sensitive device which reacts immediately to a small electric current leak by
stopping the electricity flow. Your local electrician can help you decide which
type is best for you – a portable unit that plugs into the electrical outlet or
permanent unit installed by your electrician. The national electrical code now
requires GFCI’s in bathrooms, garages and outdoor outlets of all new homes.
WHY DO YOU NEED A GFCI?
Electricity and water don’t mix. If your appliance falls into water while plugged
in, the electric shock can kill you. Even if the switch is “OFF”. A regular fuse or
circuit breaker won’t protect you under these circumstances. A GFCI offers far
greater protection.
APPLIANCE LEAKAGE CIRCUIT INTERRUPTER (ALCI)
The appliance is provided with an ALCI. This safety feature renders the tool
inoperable under some abnormal conditions, such as accidental immersion in
water. Check the ALCI safety feature every time you use the appliance. To make
sure the ALCI is functioning properly and the exclusive water sensing system is
working, perform the following test: requires GFCI’s in bathrooms, garages and
outdoor outlets of all new homes.
USER MAINTENANCE INSTRUCTIONS
Never block or clog air intakes, as this will cause the appliance to overheat. The
appliance has no user serviceable parts. Any servicing should be performed by
an authorized service representative or a professional center. Never allow the
power cord to be twisted, pulled, bent, or wrapped around the appliance. If
the cord is twisted, untwist the cord before use. When not in use, the appliance
should be stored in a safe, dry place, out of children’s reach.
