10
Retrigger/Shift Button:
The loop will reset to the start position set by the
Start
parameter when the
Retrigger/Shift Button
is pressed.
•
If deck 2 is out of phase with deck 1 and the
Link Toggle
is enabled,
pressing the
Retrigger/Shift Button
of deck 2 will spin the tape in
either direction to resynchronize with deck 1.
•
The
Retrigger/Shift Button
is also used for entering alternate modes
(See the
Latching & Momentary Recording
,
Input Monitoring
Modes
,
Looping & One-Shot Record Modes
,
Looping & One-Shot
Playback Modes
,
Save & Load
,
and
Time Modes
sections for
more information).
Retrigger Input:
The loop will reset to the start position set by the
Start
parameter when a trigger or gate signal is present at the
Retrigger Input
.
Clock Output:
The
Clock Output
generates a trigger signal based on
the size of the loop and the value set by the
Time
knob.
Time Indicator:
The
Time Indicator
illuminates white when a trigger
signal is generated at the
Clock Output
. It will also illuminate amber
when
Time Modes
are enabled (See the
Time Modes
section for
more information).
Time:
The
Time
knob sets the multiplication factor of trigger signals
generated at the
Clock Output
.
1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 16, 24, 32, 64
1 - 64 Divisions
1
2
3
4
..............
12
16
24
32
64
1 Clock
Division
Clock Divisions
Shortest
Decay Time
(Old Tape)
Infinite
Decay Time
(New Tape)
Tape Decay Mode
500ms
3 Seconds
(Mono Tap)
(Multi Tap)
Complex
Diffusion
Network
Delay
