Instrumax SNIPER 50 PLUS, Operating Manual

Page: 5 / 48

5
Selecting Units
Press and hold the button (6) for 2 sec. until the desired unit
is displayed.
Illumination
Press and hold the button (1) for 2 seconds to switch the
illumination on or off.
Clear-Key
Cancel the last action. Press button (7).
MEASUREMENTS
Single distance measurement
Press button (4) to activate the laser. When in continuous laser
mode, press this button to trigger the distance measurement
directly.
Press again to trigger the distance measurement. The result
is displayed immediately.
Continuous Measurement
Press and hold the button (4) for about 2 seconds to start
continuous measuring.
Minimum/ Maximum measurement
This function allows the user to measure the minimum or max-
imum distance from a fixed measuring point. It is commonly
used to measure room diagonals (maximum values) or hori-
zontal distances (minimum values).
Press and hold down the button (4). Then slowly sweep the
laser back and forth and up and down over the desired target
point-(e.g. into the corner of a room).
Press to stop continuous measurement. The values for maxi-
mum and minimum distances are shown on the display as well
as the last measured value in the summary line.
FUNCTIONS
Addition / Subtraction
Measure the distance. Press button (2): next measurement is
added to the previous one. Press button (6): next measure-
ment is substracted from the previous one.
The result is displayed in the main line. Previous value is dis-
played in the lines 1 and 2.