InstroTek
6
Safety Precautions
Always follow these basic safety precautions when using electrical or pump
appliances:
Read all instructions carefully.
Take notice of all warning labels located on the CoreLok.
Do not tip the CoreLok on its side.
Do not use on wet surfaces.
Do not immerse any part of the CoreLok, the CoreLok cord or plug into
water or other liquids.
To disconnect, grip plus and pull from wall outlet. Do not disconnect by
pulling on the cord.
Do not allow cord to dangle over or touch hot surfaces.
Do not operate the CoreLok if the cord is damaged in any way.
Do not place on or near a heat source.
Use of accessory attachments not recommended or sold by InstroTek may
be dangerous and my void your warranty.
Do not operate the CoreLok with the housing removed.
Do not operate if the chamber lid appears to be damaged or cracked.
Do not lay hand on the intake to check pump suction. Exposure of any
part of the body to the vacuum can result in personal injury to the
exposed part.
Never operate the pump with an open, accessible inlet. Vacuum
connections, oil filling opening or oil draining opening must not be
opened during operation of the pump.
Beware of hot surfaces that can cause burns. The operating pump can
have surfaces that reach temperatures higher than 80 C (175F).The bag
sealing edge will still be hot immediately after operation, so avoid
contact.
Only allow authorized personnel with proper machinery operating
knowledge to transport, install, operate, perform maintenance (servicing)
or dispose of hazardous wastes.
Do not use for other than intended use.
