Page 2 of 3
Rev. 01-14-2011
Smarthome Limited Warranty – Smarthome warrants to original consumer of this product for a period of 2 years from date of purchase, this product will be
free from defects in material & workmanship & will perform in substantial conformity with its Owner's Manual. Warranty shall not apply to defects caused by
misuse or neglect.
U.S. Patent No. 7,345,998, International patents pending © Copyright 2011
Smarthome, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
Quick-Start Guide
INSTEON Energy Display
*Setup Modes will automatically time out after 4 minutes.
**Temperature Calibration Mode will automatically time out after 1 minute.
Setup Modes
NOTE: Circled text indicates blinking text on the Energy Display screen.
To enter Setup Mode, press & hold the Mode button for 3 seconds.
To exit Setup Mode:
•
Tap the Refresh button to accept the current value
•
Wait for Energy Display to time out and automatically accept the current value (~1 minute)
•
Tap the Mode button to accept the current value and move to the next Setup Mode
Once Energy Display exits a setup mode, it will return the screen to Display Mode.
Cost Mode
Range is 0.1 to 999 cents/kWhr ($9.99/kWhr). Once the counter reaches 99.9¢, it will reset to 100¢. The default is 10.0¢.
Button Action
Mode
Tap to cycle to the next setting mode (Temperature Format)
Tap to increase the cost by 0.1¢ until cost exceeds 99.9¢. If cost is 100¢ or greater,
cost increases by 1¢.
Up
Press & hold to continuously increase cost
Tap to decrease the cost by 0.1¢ if cost is between 0.1¢ and 99.9¢. If cost is 100¢ or
greater, decreases by 1¢.
Down
Press & hold to continuously decrease cost
OK
Tap to accept current Cost setting and exit Setup Mode
Set
button
N/A
Temperature Format Mode
Range is 0 to 199 degrees. The default is Fahrenheit.
Button Action
Mode
Tap to cycle to the next setting mode (Display Mode)
Up
Down
Tap to toggle the temperature display between Celsius and Fahrenheit
OK
Tap to accept current Temperature Format setting and exit Setup Mode
Set
button
N/A
Linking Energy Display to an INSTEON Meter Device
1) Make sure the meter device is properly installed with the appliance you wish to monitor
2) Tap the 1/2/3 button until the desired meter position is blinking (Meter 1, 2, or 3)
3) Set Energy Display to Linking Mode* by pressing & holding the Refresh button until it beeps (3 seconds)
The Energy Display Status LED should begin blinking green
4) On the meter device, press & hold the Set button for 3 seconds
Energy Display should beep and its Status LED should stop blinking and turn off
5) Confirm that Linking was successful by checking the Energy Display screen
The Energy Display screen should display information for the meter device you just Linked to
Complete Instructions, Troubleshooting, and Tech Support
Owner’s Manual:
www.smarthome.com/manuals/2448A2.pdf
Call: INSTEON Gold Support Line at 800-762-7845
Calibrating the Temperature
1) Set Energy Display to Temperature Calibration Mode** by pressing & holding the Mode and Refresh buttons simultaneously
until the temperature setting begins blinking (3 seconds)
2) Use the Restart and 1/2/3 buttons to set the local temperature (based on a thermostat or other device)
•
Tapping the Restart button will increase the temperature by one degree
•
Tapping the 1/2/3 button will decrease the temperature by one degree
3) When you reach the correct temperature, tap the Refresh button to accept the local temperature
The temperature setting should no longer be blinking