![background image](http://html1.mh-extra.com/html/insteon/2452-222/2452-222_quick-start-manual_2069914003.webp)
2453-222/2453-422/2453-522 Rev. 8/13/2012 9:25 AM / See Owner’s Manual for Warranty Information.
Protected under U.S. and foreign patents (see
www.insteon.com
)
© Copyright 2012 INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
To determine DIN Rail module’s current switch operation mode, simply tap Set button:
If it beeps, DIN Rail module is configured for a single momentary switch
If it double-beeps, DIN Rail module is configured for a dual momentary switch
If it triple-beeps, DIN Rail module is configured for a latching switch (default)
Change
to Single Momentary Mode
1) Press and hold Set button until it beeps
LED will start blinking green
2) Press and hold Set button until it beeps again
LED will start blinking red
3) Press and hold Set button until it beeps a third time
LED will start blinking green
4) Slowly tap Set button four times
LED will continue blinking green
5) Press and hold Set button until it double-beeps
LED will stop blinking
6) Test mode change by tapping switch on and off
Load will respond appropriately
Change to Dual Momentary Mode
1) Press and hold Set button until it beeps
LED will start blinking green
2) Press and hold Set button until it beeps again
LED will start blinking red
3) Press and hold Set button until it beeps a third time
LED will start blinking green
4) Slowly tap Set button five times
LED will start double-blinking green
5) Press and hold Set button until it double-beeps
LED will stop blinking
6) Test mode change by tapping switch top and bottom
Load will respond appropriately
Change to Latching Mode (default)
1) Press and hold Set button until it beeps
LED will start blinking green
2) Press and hold Set button until it beeps again
LED will start blinking red
3) Press and hold Set button until it beeps a third time
LED will start blinking green
4) Slowly tap Set button six times
LED will continue blinking green
5) Press and hold Set button until it double-beeps
LED will stop blinking
6) Test mode change by tapping switch on and off
Load will respond appropriately
Make DIN Rail On/Off a Responder
1) Press and hold controller Set button until it beeps
Controller LED will start blinking green
2) Adjust load connected to DIN Rail module to desired level
3) Press and hold DIN Rail module Set button until it double-beeps
Controller will double-beep and its LED will stop blinking