2242-422, 2242-442, 2242-522 Rev. 10/23/2012 6:34 PM / See Owner’s Manual for Warranty Information.
Protected under U.S. and foreign patents (see
www.insteon.com
)
© Copyright 2012 INSTEON, 16542 Millikan Ave., Irvine, CA 92606, 800-762-7845
+
+
Leave approximately 6.35mm (.25”)
gap for proper mounting of Hub
Mount Hub on Wall
To free up shelf or desk space or to achieve maximum communication range, hang INSTEON Hub high on a wall just
like a picture. Simply screw two screws (we recommend using #6 drywall screws) through the marks in the drawing
below (leaving head of screw about ¼” from the wall) and hang Hub on the screws (you can then tear this sheet off).
Support
For the complete Owner’s Manual and current Quick Start Guides, visit:
http://www.insteon.com/support
Call: INSTEON Support Line at 800-762-7845
Certifications
Certification
This product has been thoroughly tested by Intertek ETL, a nationally recognized independent third-party testing laboratory. The North American ETL Listed mark
signifies that the device has been tested to and has met the requirements of a widely recognized consensus of U.S. and Canadian device safety standards, that
the manufacturing site has been audited, and that the manufacturer has agreed to a program of quarterly factory follow-up inspections to verify continued
conformance.
FCC and Industry Canada Compliance Statement
This device complies with FCC Rules Part 15 and Industry Canada RSS-210 Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement.
The digital circuitry of this device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio and television reception. However,
there is no guarantee that interference will not occur in a particular installation. If this device does cause such interference, which can be verified by turning the
device off and on, the user is encouraged to eliminate the interference by one or more of the following measures:
- Re-orient or relocate the receiving antenna of the device experiencing the interference
- Increase the distance between this device and the receiver
- Connect the device to an AC outlet on a circuit different from the one that supplies power to the receiver
- Consult the dealer or an experienced radio/TV technician
WARNING: Changes or modifications to this device not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
ETL/UL Warning (Safety Warning)
CAUTION:
To reduce the risk of overheating and possible damage to other equipment, do not install this device to control a receptacle, a motor-operated
appliance, a fluorescent lighting fixture, or a transformer-supplied appliance.
Gradateurs commandant une lampe a filament de tungstene – afin de reduire le risqué de surchauffe et la possibilite d’endommagement a d’autres materiels, ne
pas installer pour commander une prise, un appareil a moteur, une lampe fluorescente ou un appareil alimente par un transformateur.
