6.0 - OPERATION
IMPORTANT: DO NOT SWITCH MACHINE ON UNTIL INSTALLATION IS COMPLETE AND ALL
ELECTRICAL/PLUMBING CONNECTIONS HAVE BEEN MADE.
●
Switch machine on by pressing the small button at the top of the display panel [under-counter
unit]. The boiler will run through an initial self diagnostic check and various messages will display
within the window. Providing the water supply is present, the machine will start to fill and the
message
“BOILER FILLING”
will be displayed.
(If the machine does not fill to its pre-set level within 6 minutes the display will read
“NO WATER”
. If this
happens, check that the water stop valve is turned on and there are no kinks in the inlet hose. If these are in
order, check that the small plastic filter in the water connection point on the machine is not clogged with
debris. To clear the warning, switch the machine off at the mains and then back on again).
●When the water level reaches the boiler’s bottom sensor, the heater will be switched on. The
display will read
“BOILER HEATING”.
●
When the correct temperature has been reached, the display will read
“BOILER READY”
and the
green tick in the display will illuminate. In addition, the water font button will illuminate RED
IMPORTANT NOTE: In daily use you may use the boiler as soon as the water font button illuminates
RED - BUT ON FIRST INSTALLATION YOU SHOULD WAIT AT LEAST 10 MINUTES BEFORE STARTING
TO USE THE WATER.
●
Your machine will not fill completely at once. The water input is electronically controlled to obtain
maximum output, temperature and efficiency.
IN DAILY USE - switch on and wait for the water font push-button to illuminate RED. The water will
then be at the correct temperature.
●
To dispense hot water, place cup on drip-tray and press button.
7.0 -
OPTIONAL “TIMED” DISPENSE:
This function is appropriate when the cup/teapot being filled is always the same size/capacity.
To change boiler from “on
-d
emand” default setting to “Timed” dispense:
•
Switch off on front of unit
•
Unplug from mains power supply and wait 10 seconds.
•
Plug boiler back in and at the same time, press & hold the dispense button for 5 seconds.
Boiler will either start to fill with water or the dispense button will begin to flash (depending
on water level in tank).
•
Place vessel on drip-tray
•
Press & hold the dispense button to fill vessel to the required level. Release button to stop
dispense (NOTE: This can be repeated as many times as necessary, to get the level
correct).
•
Once level in vessel is correct, press the ON/OFF button (below display) to save the
measured dispense amount (this saves the setting and puts the boiler into standby mode).
•
To continue, switch boiler back on by pressing the ON/OFF button again.
•
The boiler will now dispense the measured amount into the cup/teapot, each time the
button is pressed.