Safety Controls:
The majority of possible faults have been
covered above. However, in certain circumstances,
one of two different safety controls within the boiler
may have activated;
1).
Over-boil safety
cut-out – activates if boiler
produces excess steam. This can be due to:
• lime-scale within the tank.
• a temporary interruption in the water supply.
• a faulty temperature sensor or internal
component (triac).
To Reset Boiler:
Switch off at the mains power
supply and allow the boiler to cool down for ten
minutes before switching back on (the safety device
should automatically reset).
Earlier Models:
The over-boil cut-out will require a
manual reset. Contact Instanta Technical Support
department for assistance with this.
2).
Boil-dry Safety
cut-out. This operates if the boiler
has been boiled dry, for example, due to lime scale
build-up or water starvation.
The boil-dry safety switch will require resetting.
Please contact our Technical Support department for
assistance with this.
Safety Caution: Isolate boiler from power supply
before proceeding:
In any of these events the indicator lamp will flash red
or green or red and green. If the problem reoccurs
contact the
Instanta Service Department
- 01704 502911
Service/Technical Support
Tel: 01704 502911
To ensure your service enquiry is handled as
efficiently as possible, please have the following
information available;
• Brief description of problem.
• Product Type (model).
• Serial Number (label on right-hand side
of machine).
This is essential.
Guarantee
Your boiler is guaranteed for twelve months from
date of installation.
Our guarantee includes on site labour and parts
for problems caused by fault of manufacture and
component failure with the following exclusions:
• Problems caused by hard water and lime scale.
We regret that we cannot be held responsible
for problems caused by hard water.
• Dripping Taps. These components are subject
to wear and tear but in the event of a tap failing
within twelve months of installation, we will be
pleased to replace the tap assembly by post.
Fitting is very simple and requires no tools.
An engineer call out is not necessary.
• Accidental damage, misuse or use not in
accordance with these instructions and damage
caused by incorrect installation.
The manufacturer disclaims any liability for incidental,
or consequential damages.
6
7
