FOR USE BY QUALIFIED PERSONNEL ONLY
4
Operation
1.
Turn the power on by pressing the
POWER
button on the controller.
2.
Set desired temperature and time. Open the
upper platen arm to its fully open position, away
from the lower platen. (See Solid State
Controller Section)
3.
Allow the machine to warm up until the selected
temperature is reached.
4.
Set the desired pressure by adjusting the
pressure knob on top of the machine
counterclockwise to increase pressure.
5.
Place the substrate on lower platen, smoothing
out all wrinkles. Push and hold the cap retainer
in the down position. For a cap, pull the
sweatband out, place the crown on the lower
platen.
6.
Position transfer or lettering on substrate.
7.
Close the machine by pulling handle down into
locked position.
8.
The timer will start automatically and a buzzer
will beep at the end of the time cycle.
9.
At the end of the time cycle, open the machine
by lifting handle to the full open position.
10. Unlock cap retainer and remove substrate.
NOTE
The
lower
platen
may
be
adjusted
to
accommodate
various
caps,
sleeves,
pant
legs.
Slide
the
lower
platen
z
bracket
assembly
by
loosening
the
lock
down
knob
located
in
the
base
of
the
of
the
z
bracket.
Move
the
complete
lower
platen
assembly
forward
or
backward
to
the
desired
location.
Once
in
position,
lock
down
the
complete
assembly
by
tightening
down
the
lock
down
knob.
Environmental Conditions
Only operate Insta heat seal machines under
suitable environmental conditions.
1.
Placed on a even, non flammable surface.
2.
Can support a minimum of 150 lbs. if placed
above a platform.
3.
Do not restrict access to the main power
switch.
4.
Maintain a clearance around any forms of
liquid.
5.
Do not over extend the power cord.
6.
The operational voltage should not be 10%
max/min of the rated value.
7.
Avoid voltage spikes.
