2. SWING ACCESSORY
PART NO
NAME
Q'TY
PART NO
NAME
Q'TY
1
Rope
1
G4
M8 U-Screw
2
2
Swing Seat
1
U2
M8 Safety Nut
4
3
Adjust Lump
2
X2
M8 Nylon Washer
4
1 2 3 G4
U2 X2
EXCURSUS:
1: Thread the rope through the holes in the seat making sure that it fits into the gate underneath in the diagram. The length of
rope should be the same on both sides. Tie a knot in the rope on both sides of the seat as shown in the diagram, with the knots
as close as possible to the seat.
2: Fit the ends of the
rope
through the holes of the adjust lump
as shown in the diagrams -through hole “B”, back through “C”,
through “D”, then thread under the loop in the rope at the back. Adjust if needed, so that the seat is level and at the required
height.
THE SEAT IS 400-600 mm
HIGH FROM THE GROUND
3: Hang two adjust lump (3) onto U-screw (G4), then assemble the U-screw onto the top support bar, fasten them with safety
nut (U2) and washer (X2). Adjust the swing rope (1) to ensure the swing’s balance and the
height of the seat between 400 to
600 mm the ground.
ASSEMBLE INSTRUCTION OF THE SWING
