17
36
Right Upright Decoration
Cover-R
1
86
Right Wheel Frame
1
37
Driving Belt
J170-6
1
87
Safety Switch
1
38
EVA Pad
1
88
Nut
M5
4
39
Moving Wheel
2
89
Pulse Up Wire
2
40
Cushion Pad
8
90
Incline Key-Press Up Wire
2
41
Flat Foot Pad
4
91
Bolt
M8*35
2
42
Power Wire Clip
1
92
Left Handle Bar Decoration
Cover
2
43
Running Belt
1
93
Right Handle Bar Decoration
Cover
2
44
Safety Key Fixing Frame
1
94
Left Upright Decoration
Cover-L
1
45
Safety Key Spring Ball
1
95
Right Upright Decoration
Cover-L
1
46
Anti-Slip Pad
2
96
Left Decoration Cover-R
1
47
Bolt
M6*16
4
97
Outer Tube Sleeve
2
48
Bolt
M8*55
2
a-1
AC Single Wire
1
49
Bolt
M10*80
1
a-2
AC Single Wire
1
50
Nut
M10
12
98
Cushion Pad
6
TROUBLE SHOOTING GUIDE
1.
E01
—Communication failure:
The probable reason is that the communication from the console to the bottom control board is stuck
or the computer is defective. Check every single connection part of the wires from the console to the
bottom control board and make sure that all the wires are connected well. If the problem is caused by
the defective wires, do the replacement by the new wires, or change a new Computer.
2.
E02:
The Probable reason is that the IGBT of the control board, or the Control Board is damaged. Use the
Multi-meter to test if the IGBT of the bottom control board is burnt out, change either the IGBT or the
whole bottom control board.
3.
E03
—No sensor signal:
The probable reason is that the light speed sensor signal has not been received during 10 seconds,
check if the sensor of the bottom control board is install well, if not, please re-install again. Check if the
sensor plug is connected well or if the light speed sensor is broken, re-connect the sensor plug or
change the magnetic sensor with the new one. Check if the control board is work well or the wire is
connected well. If not, connect it well or change a new control board.
4.
E05
—Control Board and Motor Damaged:
The probable reason is that the Control Board & the Motor is damaged. Please change a new Control
Board or DC Motor.
5.
E06
—Motor Wire and Control Board wire connection failure:
The probable reason is that the motor wire and control board wire is not connected well or the DC
motor or Control Board is damaged. Please check if the DC Motor or Control Board is damaged, or
connection wire and if it is connected well. Change the DC Motor or Control Board or reconnect the
connection wire.
