5
ASSEMBLY STEPS
WARNING:
Adult assembly required.
NOTE:
Wrench included.
Remove all parts from the box and check if no part is missing.
Remove protective plastic caps from handlebar (A) and front fork (B) before assembly.
Height of the handlebars: 71 cm
Put on the handlebar stem (A) these components in right order: basket
(H), plastic cover of clamp (D) and clamp (C).
Place lower plastic sleeve (F) onto the frame (G). Its wider side must be
down. Insert front fork into the frame (G) and slide it till stop. It has to
protrude from the frame. Place upper plastic sleeve (E) onto the frame
(wider side must be up), so that it assures the front fork (B). Insert the
handlebar stem (A) into the frame (G) (basket-hole must be on the back
side
– facing the rider). Adjust height of the handlebars. Slight clamp (C)
on the front fork (B). The screw must be on the back side of the stem
(facing the rider). Put the handlebar stem (A) in line with the front wheel.
Pass a screw through the clamp hole and secure with a nut. Pull the
plastic cover (D) down onto the clamp.
Stick spindle (L) through the frame (G) and insert wheels (K). Ensure
them with safety nuts (M). Put covers (J) on the nuts (including nuts on
the front fork). Insert the spring (P) into the frame (G) and put the rear
fender (O) on it. Rear fender serves as a brake. Snap it in the frame (G).
Attach the basket (H) to the handlebar stem (A) with self-tapping screw
(I). Turn this device over and remove plastic insulations to activate
flashing during riding.
SAFE USING
Ride carefully and pay attention, although it is very easy to ride it. Keep balance to avoid a fall
and injury.
Stand on the footstep and push off with one leg. The other leg is on the footstep. Don’t forget
to switch the push-off leg.
Grip the handlebars firmly with both hands. Decrease your speed while turning.
Decrease your speed before getting off this device. After it has been stopped totally, put one
foot on the ground. Subsequently do the same with your second foot.
