10
4. HANDLEBAR
SUPPORT
FRAME,
HAND
PULSE
HANDLEBAR,
COMPUTER
•
Remove four bolts M8x38 (74), four spring washers
ø8 (77) and four washers (78) from the
main frame (12).
•
Attach the middle handlebar support frame (81) onto the main frame (12) with four bolts
M8x38 (74), four spring washers
ø8 (77) and four washers ø8 (78). Use the S6 Allen wrench
with the Phillips screwdriver and tighten the bolts properly.
•
Connect the sensor wires (80) that come from the middle handlebar support frame to the
sensor wire (13) that comes out from the main frame.
•
Put the cable end of resistance cable of the tension control knob (32) into the spring hook
tension cable (38) as shown in drawing 1. Pull the resistance cable of the tension control knob
(32) up and force it into the gap of the metal bracket tension cable (38) as shown in drawing 2.
•
Attach the tension control knob (32) onto the hand pulse handlebar support frame (81) with
one screw M5x15 (33). Use the screwdriver and tighten both screws M5x15 (33) until they are
firm.
•
Attach the middle handlebar (87) onto the top end of the middle handlebar support frame (81)
using two screws M8x35 (82), big arc washer
ø8x ø20x2.0 (75) and two cap nuts M8 (76).
Use the flat wrench and tighten the cap nuts properly.
5. COMPUTER AND DUMBBELL RACK
•
Connect the sensor wire (80) and hand pulse wire (84) to the wire that comes from the
computer (43).
•
Remove four screws (88) from the back of the computer (43) and then attach the computer
(43) to the plate of the middle handlebar using four screws (88) that have been removed.
•
Remove four M6*15 screws (90) from the middle handlebar support frame (81) and attach two
dumbbell racks (89) onto the middle handlebar support frame (81) with four screws M6*15
(90). Use the screwdriver and tighten both screws M6x15 (90) properly. Finally place the
dumbbells (2 and 3 pounds, 92/91) onto the dumbbell rack (89).
