7
Rolling Base Assembly:
1. If ordering footrests, slide the footrest clamp over
the leg tubes making sure the notched end faces
upward. Align the center slot on the clamp to
the holes on rolling base leg (Fig 7). Secure the
clamps with bolts. The height is adjustable and
can be re-positioned when the seating is fully
assembled for correct fit.
2. Insert the casters into the socket on the bottom of
the individual leg tubes (Fig 8).
3. Insert the leg tubes into the rolling base by
depressing the locking buttons and sliding the leg
tube up the frame.
Seating and Rolling Base (Shuttle) Assembly:
4. Insert the guide rail hooks into the guide rail and
slide the seating frame assembly onto the rolling
base. (Fig. 9). Be sure to slide the seating all the
way until the safety latch locks into position on the
base (Fig. 10).
Note: To remove the seating from base, release
the safety latch in the back and press the Slider
Safe™ button (Fig. 11).
5. If ordering with footrests, insert them by aligning
the slots on the footrests with the notches onto
the footrest clamps.
Tub Base Assembly:
6. Unfold the tub base legs by pulling the legs out
and rotating them into position. Each leg is in
position when it locks into the slots at the bottom
of the frame rail (Fig 12).
Note: When unfolding the legs, grab the leg on the
darker-colored pivot section as close to the top
as possible. This will prevent damage to the leg and
make it easier to unfold.
Note: When folding the tub base for storage, fold
the two front legs (the legs closest to the latch) first.
The adjusting legs do not have to be removed when
folding for storage.
Figure 12
Slot
Fine-tuning knob
Figure 10
Figure 11
Figure 9
Guide Rail
Guide Rail Hooks
ASSEMBLY OF THE TRANSFER SYSTEM
Figure 8
Align slot to
the holes
Notch
Figure 7
