Inspire Home Automation
www.inspirehomeautomation.co.uk
[email protected]
01202 798390
8
9
Pairing
Your units were all pre paired before they left the factory. If they do not connect up correctly, and you
have waited for at least 10 minutes, the most likely reason is radio range, see the section on ‘Radio
Signal’ above.
When all units are connected, you should see:-
Gateway - Green RF light. At least one device is connected to the Internet Gateway.
Thermostat - RF symbol lit in bottom left corner. Connected to Gateway.
Programmer - Green CH light(s). Thermostat connected to Programmer.
In the unlikely event that you need to pair the units to each other then:
To Pair the Programmer to the Internet Gateway.
Press the pairing button on the back of the gateway, (The RF light will flash amber)
Long press the two outside buttons until all three lights start flashing, then short press the two outside
buttons
To Pair the Thermostat to the Internet Gateway.
Press the pairing button on the back of the gateway, (The RF light will flash amber)
Press and hold the M & S keys on the Thermostat for 5 seconds, the RF symbol, bottom left should start
to flash.
To Pair the Thermostat to the programmer
(Only possible after both Thermostat and programmer are
connected to the Internet Gateway)
Long press the two outside buttons, this will make all three lights flash. Then press the appropriate button
(CH) to pair the central heating channel to a thermostat, this will start the light flashing, press the ‘S’ and
‘-’ keys on the Room Thermostat until the RF indicator in the lower left hand corner starts to flash.
