Inspire 1334042, User Manual, Page: 10 / 21

Pg. 10 V05032021
STEP 2
A. Install Guide Rods (#7) into holes on bottom Frame using M10 x 80 Allen Bolt (#18) and Ø 10 Spring Washers (#25) .
Tighten bolts now.
B. Install Rubber Bumpers (#16) on each Guide Rod (#7) . Slide fifteen 10lb Weight Plates (#10) from the top of Guide
Rods (#7) down to the Rubber Bumpers (#16) . Make sure the weight sticker cut out is facing the inside of the
machine.
C. Remove the two M10 x 19 Allen Bolts (#21) , Ø 10 Spring Washers (#23) , and Ø 10 Washers (#25) which were pre-
assembled in the factory to hold the Guide Rod Bracket (#6) . Slide the Selector Stem Assembly (#8) onto the Guide
Rods (#7) . Install Large Pulley (#30) and wrap the cable between the U-shaped Pulley Bracket (#27) using the M10 x 2
(#29) Allen Bolt located on the Selector Steam Assembly (#8) .
D. Hold the Selector Stem Assembly (#8) above the weight stack to make it easier to install Guide Rod Bracket (#6) on
Guide Rods (#7) .
E. Once the Guide Rod Bracket (#6) is installed onto the Guide Rods (#7) , Push the Guide Rod Bracket back into the
upright.
F. Secure the Bracket back to the upright frame with the two M10 x 19 Allen Bolts (#21) , Ø 10 lock Washers (#23) , Ø
10mm Washers (#25) .
G. Lower the Selector Stem down onto the top of the weight stack.
H. Check all the cables to make sure they are on track on the pulleys.
I. Peel off the weight resistance label from the Resistance Label Set (#26) and attach to the plates.
J. Insert the Weight Selector Pin (#9) into the weight stack.
K. Lubricate the Guide Rods with super lube or lube provided in Hardware Pack.
L. If Needed, Adjust the Cable tension by first loosening the M10 x 2 (#29) Allen Bolt located on the Selector Steam
Assembly (#8) then rotate the Tension Adjustment Plate (#28) clock or counterclockwise to move the Bolt and the
Large Pulley (#30) up and down along the open track inside the U-shaped Pulley Bracket (#27) . Once desired tension
is achieved, securely tighten the Bolt (#29) back.
M. Repeat the Procedure A through N above to install the other set of weight plates to the Left Station. (#2)