5
6
Power on/off:
Press the power key for 2 seconds to power On or Off.
The indicator can identify the load cell. You should check the
model whether it is you want. Check Battery Icon. If the power is
low, should be recharged.
Testing:
After completion of the test preparation, testing can be done.
3
4
1.
Select Units:
The torque gauge has a variety of measurement units, select the
appropriate unit of force.
2.
Select Test Mode:
This series torque gauge has 4 kinds of measurement test mode
can choose.
Track:
The real time measuring mode, under this mode,
press the zero key the torque gauge will be cleared
(remove tare).
Peak:
Peak readings will not change until a higher value is
measured. Under this mode, press the zeroing key the
torque gauge will update the display immediately.
Preset:
The tolerance limits can be set for GO/NG
measurement also. If you set the alarm on and a valid limit,
The icon will be displayed for within limit, lower than lower
limit or exceed upper limit.
First Peak:
In this mode, the gauge can capture the first
peak value of force, when the force value decreased to
reach the drop ratio. The drop ratio can be set in menus.
Double Peak:
In this mode, the gauge can capture two
peak value of force, when the force value decreased to
reach the drop ratio. The drop ratio can be set in menus.
Zeroing:
Press zeroing key to clear the torque gauge in track mode for
removing the tare.
5
Storage/print:
Measured results can be stored in the torque gauge, so that you
can review or print them later.
Under the measure interface, Press the key to save value
measured, and the save icon will be displayed.
6
Menu
Unit
Group
Measurement
Test Mode
Storage Mode
Delete All
Delete Selected
Delete All
Print Selected
Memory
Up load data
Display Mode
Power Off
Backlight
Key Tone
Language
Date/Time
Diagram scale
Key Setting
Default Setting
System
Information
Calibration
Measurement
( has been selected
)
Memory
System
Calibration
