7
8
12
Height measuring:
13
Stake-out:
14
Memory recall:
Long press to recall the memory.
15
FAQ
And
Solution
Error code:
Code
Err01
Err02
Err03
Err04
Err05
Err06
Err07
Standby screen
Area measuring
Short press to measure length, width and height follow the
instruction on the screen, then the volume is showed. You can
change the unit by long pressing .
Short press to select:
Single Pythagoras, Summary of two
Pythagoras, Subtract of two Pythagoras.
Short press to measure the lengths follow the instruction
on the screen, then the height will be displayed on the screen.
You can change the unit by long pressing .
Single
Summary
Subtract
Short press three times to edit the length of stake.
Short press and to set the value. When value is decided,
press to finish setting.
to reset zero.
Short press
When in dyna-measuring mode, you can get every stakes you
need follow the arrow.
To look up the last 20 measures by short pressing and .
Back-light and laser pointer switch:
Long press to enable and disable the back-light.
Long press to enable and disable the laser beam.
Description
Out of measuring range
Reflected signal is too weak
Out display range
Pythagorean calculation error
Low battery
Out of working temperature
Ambient light is too strong
max value:99999
Solution
Measure in a proper range
Select a batter surface
Divide calculation in middle steps
Check and verify values and steps
Install a new battery
Measure in an environment within
Measure in a darker place(shadow
are correct
specified working temperature
target)
