9
8
Scalding Hazard:
The faucet dispenses
near-boiling (96ºC) water which can
instantly cause scalds or burns. Use care
when operating this appliance.
Property Damage:
Join remaining tube
to cold water supply only.
Turn on the cold water supply.
Depress the tap
HOT
handle and hold
it until water flows from the spout
(approximately 1 to 2 minutes).
Run the water for at least 2 minutes to
flush lines (both the hot and cold handles
independently if applicable).
6
Check all connections to ensure they are
tight and that there are no leaks.
Plug in instant hot water tank.
Water will be cold at first.
Allow 12-15 minutes for water to reach
target temperature.
Gurgling or hissing is normal during the
initial heating cycle.
5
Electric Shock Hazard:
A standard grounded
outlet within 760mm of the tank
is required under the sink. Do not use
an extension cord set with the tank.
FINAL WATER CONNECTION
FILL TANK & THEN CONNECT POWER
b
a
a
NOTICE
NOTICE
Electric Shock Hazard:
Using an ungrounded or improperly connected
appliance can result in serious injury or death from electrical shock.
Property Damage:
To avoid water damage, replace any loose or split tubing.
Periodically inspect the unit for any signs of leakage and immediately remove from
service any unit suspected of leaking.
Personal Injury:
This tank is a non-pressurized tank. DO NOT modify this system.
DO NOT close vent tube or connect other type tap or valves to the tank. Use only
the InSinkErator tap supplied. Use only parts provided. Contact an authorized
InSinkErator Service agent for repairs or replacement components.
This appliance must be grounded.
This instant hot water tank is equipped with a cord that has a
grounding conductor and a grounding pin. The plug must be connected to an appropriate outlet that is
properly installed and grounded in accordance with all local codes and ordinances. Do not modify the plug
provided with the appliance – if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
Check with a qualified electrician or serviceman if you are in doubt as to whether the instant hot water tank
is properly grounded.
Fire Hazard:
To minimize possibility of fire, DO NOT store flammable items such as
rags, paper or aerosol cans near the tank. DO NOT store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any other appliance.
Leak Hazard:
Regularly inspect tap and plumbing fittings for leaks, which can cause
property damage and/or could result in personal injury.
An instant hot water tank, like any water heater, has a limited life and will eventually fail. To
avoid possible property damage and personal injury, this instant hot water tank should be
regularly examined for leakage and/or corrosion and replaced when necessary. A drain pan,
plumbed to an appropriate drain or outfitted with a leak detector, should be used in those
applications where any leakage could cause property damage. To check for corrosion, exam-
ine the appearance of the dispensed water in a clear glass once every three (3) months. If
there is any discoloration or rusty appearance, unplug and drain unit as described in the
Seasonal Storage/Drainage section on page 11 of this manual. If the water discoloration
remains after draining and refilling unit, discontinue use and contact an
authorized InSinkErator service agent.
NOTICE
NOTICE
NOTICE
NOTICE
NOTICE
IMPORTANT SAFETY INSTRUCTIONS
See instructions provided with valve kit
At the other end of the white tube from the filter,
press on the:
n
9.5mm (3/8") to 1/4" BSPT fitting
or 9.5mm (3/8") to 1/2" BSPP fitting
and connect to the water supply.
n
Press in again to ensure a secure fit.
Back flow
protection valve
Wall mount clip
