19
NS-32DR420CA16/ NS-55DR420CA16
www.insigniaproducts.com
Connecting an antenna or cable TV (no box)
1
Make sure that your Insignia Roku TV’s power cord is unplugged and all connected devices are turned off.
2
Connect a coaxial cable (not provided) to the
ANT / CABLE IN
jack on the back of your Insignia Roku TV and to the
antenna or cable TV wall jack.
3
Plug your Insignia Roku TV’s power cord into a power outlet, then turn on your Insignia Roku TV.
4
On the Home menu, press or the highlight the tile for
Antenna TV
, then press
OK
.
5
Set up the TV tuner to watch broadcast TV. See
on page
6
On the Home screen, press or to highlight the
Antenna TV
tile, then press
OK
.
Coaxial cable
Antenna or cable TV
(no box)
Back of TV
Coaxial cable
connector
ANT / CABLE IN
jack
On your TV
Notes
• Use a coaxial cable to eliminate interference and noise from radio
waves.
• Do not bundle the coaxial cable with the power cord or other cables.
• If the antenna is not installed correctly, contact qualified service
personnel to correct the problem.
• If the signal level for a channel is weak, the picture may be distorted.
Adjust the antenna or use a highly directional outdoor or set-top
antenna with a built-in amplifier.
• If the picture quality is good on some channels and poor on others, the
problem may be caused by a poor or weak signal from the broadcaster
or cable TV provider.
• If you connect to cable TV without a set-top box and experience poor
picture quality, you may need to install a set-top box to improve signal
reception and picture quality. Contact your cable TV provider about
upgrading to a set-top box.
• Many high-definition (HD) channels upscale standard-definition (SD)
content. The picture displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as it would be if the
content was originally recorded in HD.
