18
NS-TWM41WH8A
www.insigniaproducts.com
INSTALLATION INSTRUCTIONS
4
Connect the ends of the water supply hoses to the water supply intake connections at the top of the washer.
Make sure that the rubber washers are in place. The water supply hose connected to the hot faucet must be
connected to the hot water supply intake and the water hose connected to the cold faucet must be connected
to the cold water supply intake.
5
Tighten the fittings by hand until they are snug, then tighten them an additional two-thirds of a turn with a
wrench.
6
Turn on the hot and cold water supplies and check all the water supply intake connections and the faucets for
water leaks.
Notes
• If you do not want to use the hot water supply
hose, insert a water intake cap into the hot
water supply intake hole. In this case, you
must select the
Tap Cold
option for the water
temperature.
• No intake cap is provided with your washer. It
must be purchased separately.
Caution
• Do not overtighten the fittings or apply tape
or sealant to the faucets or water supply
intakes. This can damage the fittings.
• Make sure that the water supply hoses are not
twisted or bent. A bent or twisted hose can
leak and cause an electric shock due to the
water leakage. To ensure the correct water
usage, connect both hot and cold water
faucets. If either or both are not connected, an
error code could occur.
NS-TWM41WH8A_17-0655_MAN_V2_EN.fm Page 18 Friday, August 4, 2017 8:10 PM