7
4-Burner Electric Range
www.insigniaproducts.com
MODELS WITH BAKING OR WARMING DRAWERS
1
Plug in the range.
2
Measure the height of your countertop at the rear of the opening (X).
3
Adjust two rear leveling legs so that the rear of cooktop is at the same height as the
counter (Y).
4
Slide unit into place.
5
Install oven racks in the oven and position the range where it will be installed.
6
Check for levelness by placing a spirit level on one of the oven racks. Take two
readings—with the level placed diagonally first in one direction and then the other.
7
Adjust front leveling legs until the range is level.
5 – FINAL INSTALLATION CHECKLIST
•
Check to make sure the circuit breaker is closed (RESET) or the circuit fuses are replaced.
•
Be sure power is in service to the building.
•
Check to be sure that all packing materials and tape have been removed. This will include tape on metal panel
under control knobs (if applicable), adhesive tape, wire ties, cardboard, and protective plastic. Failure to
remove these materials could result in damage to the appliance once the appliance has been turned on and
surfaces have heated.
•
Check to make sure that the door and drawer are parallel to each other and that both operate smoothly. If
they do not, see the Owner’s Manual for proper replacement.
•
Check to make sure that the rear leveling leg is fully inserted into the Anti-Tip bracket and that the bracket is
securely installed.
OPERATION CHECKLIST
•
Turn on one of the surface units to observe that the element glows within 60 seconds. Turn the unit off when
glow is detected. If the glow is not detected within the time limit, recheck the range wiring connections. If
change is required, retest again. If no change is required, have building wiring checked for proper connections
and voltage.
•
Check to make sure the Clock (on models so equipped) display is energized. If a series of horizontal red lines
appear in the display, disconnect power immediately. Recheck the range wiring connections. If change is
made to connections, retest again. If no change is required, have building wiring checked for proper
connections and voltage. It is recommended that the clock be changed if the red lines appear.
•
Be sure all range controls are in the OFF position before leaving the range.
6 – MODEL AND SERIAL NUMBER LOCATION
The rating plate is located above the drawer on the oven frame or on the side of the drawer frame.
Note
(On some models):
If the clock flashes “bAd” and then
“LinE” with a loud tone, the neutral connection to the
range is miswired. Check the terminal block connections
and/or house wiring to correct.
X
Y
Rating plate
NS-RNE4BWH8-C_NS-RNE4BMSS9-C_NS-RNEC4BSS9-C_18-0194_Install MAN_V1_EN.fm Page 7 Wednesday, March 28, 2018 2:26 PM
