3
NS-OTRC15SS9
www.insigniaproducts.com
1.5 Cu. Ft. Over-the-Range Convection
Microwave
Introduction
Congratulations on your purchase of a high-quality Insignia product. Your NS-OTRC15SS9 represents the state of the art in
microwave design and is designed for reliable and trouble-free performance.
This installation guide will show you how to install your new over-the-range microwave.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT – Save these instructions for local inspector’s use.
• IMPORTANT – Observe all governing codes and ordinances.
• Note to Installer – Be sure to leave these instructions with the consumer.
• Note to Consumer – Keep these instructions for future reference.
• Skill level – Installation of this appliance requires basic mechanical and electrical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered under the warranty.
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT–PLEASE READ CAREFULLY. FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED TO
AVOID SEVERE OR FATAL SHOCK.
This product requires a three-prong, properly grounded outlet for safe operation. If
not properly grounded, or if the outlet box does not meet the electrical requirements
noted (under ELECTRICAL REQUIREMENTS), a qualified electrician should be
employed to correct any deficiencies.
The power cord of this appliance is equipped with a three-prong (grounding) plug
which mates with a standard three-prong (grounding) wall receptacle to minimize the
possibility of electric shock hazard from this appliance.
You should have the wall receptacle and circuit checked by a qualified electrician to
make sure that the receptacle is properly grounded.
Where a standard two-prong wall receptacle is encountered, it is very important to have it replaced with a properly
grounded three-prong wall receptacle installed by a qualified electrician.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT, DEFORM, OR REMOVE ANY OF THE PRONGS FROM THE POWER CORD. DO
NOT USE WITH AN EXTENSION CORD.
Caution
For personal safety, remove the house fuse or open the circuit breaker before beginning
installation to avoid severe or fatal shock injury.
For personal safety, the mounting surface must be capable of supporting a total weight of 113–
135 pounds (51.3–61.2 kg). This includes the cabinet load, weight of the microwave, and
additional oven loads.
For personal safety, this product cannot be installed in cabinet arrangements such as an island or
a peninsula. It must be mounted to BOTH a top cabinet AND a wall.
ELECTRICAL REQUIREMENTS
The product rating of your microwave is 120 volts AC, 60 Hertz, 15 amps, and 1.6 kilowatts. This
product must be connected to a supply circuit of the proper voltage and frequency. Wire size
must conform to the requirements of the National Electrical Code or the prevailing local code for this kilowatt rating. The
power supply cord and plug should be brought to a separate 15- to 20- ampere branch circuit single grounded outlet. The
outlet box should be located in the cabinet above the microwave oven. The outlet box and supply circuit should be
installed by a qualified electrician and conform to the National Electrical Code or the prevailing local code.
Note:
For easier installation and personal safety, it is recommended that two people install this product.
Ensure
proper
ground
before use
