13
Insignia Single- and Dual-Tap Kegerator/Beverage Cooler
www.insigniaproducts.com
d
Attach the draft arm to the worktop with the four screws provided.
2
Attach the black plastic beer tap handle to the top of the faucet,
tightening it by hand until it's tight. Hold the silver snug ring so it does
not move.
Installing the CO
2
regulator and tank
Before installing the CO
2
regulator and tank, it’s very important that you
review this list of safety tips.
WARNING
: CO
2
gas can be dangerous. CO
2
tanks contain high-pressure,
compressed gas which can be hazardous if not handled properly. Make
sure that you
READ
and
UNDERSTAND
the following procedures for CO
2
tanks
BEFORE INSTALLATION
.
1.
ALWAYS
connect the CO
2
tank to a regulator. Failure to do so could
result in explosion with possible death or injury when the tank valve is
opened.
2.
NEVER
connect the CO
2
tank directly to the beer keg.
3.
ALWAYS
follow correct procedures when tanks are changed.
4.
ALWAYS
secure the tank in an upright position.
Note
If there is a small drip after you pour a beverage, you may have
tightened the beer tap handle too much. If so, unscrew the silver
snug ring one turn, then retighten the beer tap handle.
Beer tap handle
Draft arm assembly
Beer tube
Wing nut
Silver snug ring
NS-BK1TSS6_NS-BK2TSS6_15-0765_MAN_V3_ENG.fm Page 13 Tuesday, December 22, 2015 6:20 PM
