www.insigniarange.com
Last Modified: 07/10/2014
25
Silicone Seal where shown in red on the inside of the shower
TESTING FOR WATER LEAKS
LEAVING SHOWER 24 HOURS AFTER BUILD ALLOWING SEALENT TO CURE
With all connections tight, the waste and hoses checked, jets fully sealed, your shower
still around 18 inches from its designated final resting point and the silicone fully cured
(hence leaving for 24 hours minimum) Switch on the overhead shower NOT the massage
jets, remember these will fire water out at you and are not suitable for checking leaks as
they would normally only operate when a person is in front of them. Just use COLD water
setting as hot will make cabin misty and condensate thus the inspection becomes very
difficult. Now on the OUTSIDE of the shower inspect each joint, factory seal, hose, clip
and jet by walking from one side and going around to the back and then to the other side
finishing at the front. If you have a small leak (normally caused through insufficient sealer
or air bubble on assembly, dry the area thoroughly and reseal on the OUTSIDE. Please
remember where you see the water this may not be exactly where the leak is as it could
have run around to a low point. Never seal your inner fittings (accessories) inside unless
you feel it necessary and make sure it is thin and neat, remember you will see this for the
life of the shower! Again leave to cure and check. If all good now check shower functions
i.e. jets for back massage, foot massage, (if you have one) and finally hand show-
er, check your joints to these functions at the rear again. Never use the shower until
all
checks have been made and the installer is 100% happy in the knowledge no leaks are
present.
All good?
Now push your shower FROM THE BASE NEVER GLASS OR FRAME into its final rest-
ing position. Now you can shower in the knowledge that you have no leaks a job done
well and long product life.
Happy showering!
