BEFORE OPERATING THIS EQUIPMENT
SAFETY IS MOST IMPORTANT ASPECT AND IN NO CIRCUMSTANCES IT SHOULD BE
OVERLOOKED. THIS IS A VALVE AMPLIFIER AND BY DESIGN IT CONTAINS VERY
HIGH VOLTAGES EVEN AFTER IT IS UNPLUGGED. IN NO CIRCUMSTANCES IT
SHOULD BE OPERATED BY THE USER WITH THE BASEPLATE REMOVED. THE
TRANSFORMERS AND VALVES SHOULD NOT BE TOUCHED WHILE THE AMPLIFIER IS
POWERED.
1.
This amplifier is designed to operate at 220-230V, 50Hz ac, ensure the voltage
levels and frequency before turning it on.
2.
Ensure that the power supply has proper ground. You can test the supply outlet
with fault tester to ensure the same.
3.
Make sure you connect the speaker system of correct impedance (4 or 8ohms) in
the designated outputs.
4.
There are 2 fuse sockets installed, one for Mains & one for HT. Boith are rated
at 1 A Slow Blow type, make sure you do not used fast blow type fuse.
5.
Before turning on the amplifier make sure the standby switch is OFF. Turn it on
only after the tubes warm up, typically 30 secs at least.
