- 15 -
logo “L”(meaning left) / “R” (meaning
right) between the brush and the bottom of the unit to make sure the
brushes are correctly installed.
There is a square hole at the bottom of the side brush. Align the brush with the square hole facing down and
press it until it clicks in the unit.
BEFORE FIRST USE
Remove all packaging material and take out the foam strips (A) at both sides.
USE
1.
Install two side brushes as described above. Do not reverse the left and right side.
2.
Place the machine on the ground to be cleaned.
3.
When the machine is off, press and hold the on/off button, buzzer sounds are sent out and the two
indicator lights flash. After 3 seconds, the machine turns into the standby mode, and in this mode, the two
indictor lights both illuminate.
4.
Press the start/pause button, the buzzer sound once and after a delay of 3 seconds, the machine starts
cleaning. Now only the indicator light on the start/pause button illuminate.
5.
The machine can be installed with the mop to clean. Follow the steps below to paste the mop. In order to
avoid water stains, do not use too much water to wet the mop. The mop can be reused. Just take off the
mop and wash it; dry it before re-paste it onto the machine.
①
Rip off the two provided Velcro strips and paste them on the back of the machine as below picture shows.
②
Paste the mop onto the Velcro strips.
6.
During operation, press the start/pause button or the recharge button, the machine will stop and stay
standby.
7.
To turn off the machine, first turn the machine into standby mode, then long press the on/off button for
about 3 seconds.
NOTES:
In standby mode, the machine will automatically shut off
if there’s no operation in 5 minutes.
When a fault is detected, the error mode is entered. The indicator lights flash and the buzzer sounds.
Check it in
the section “COMMON
ERRORS” below.
RECHARGE
Charging by the charging base
1.
To help the machine find the charging base in time, it is recommended to place the charging base smoothly
on the side of the wall, and place no obstacles around the charging base within 2 meters in front and 1
