BCI Mfg Inc P.O. Box 1207 North Plains, OR 97133 [email protected]
Lower the KICKR into position as shown.
The center leg of the KICKR fits into the 2
receiver saddles on the E-flex frame.
For proper forward positioning, the center
leg of the KICKR should extend approx. 3”
(76mm) from the front saddle. A setup
block is provided as a quick way to position
the KICKR correctly.
Use the provided setup block to check
KICKR alignment. Slide the block between
the saddle clamp and the frame as shown.
First at the front clamp and then at the rear
clamp. Adjust the KICKR position until the
setup block just fits at both points. That will
ensure the KICKR is aligned with the E-
FLEX frame
Install the 2 saddle clamps and 4 wing nuts
and tighten.
The trainer should be
approximately vertical and not heavily tilted
to one side. It does not need to be perfectly
vertical to work properly. If it is tilted more
than a degree or two, you may need to go
back and adjust the support arm.
